Claremore's historic downtown along Will Rogers Boulevard and Route 66 has many older brick buildings with flat roofs, and the surrounding area has warehouses, schools, churches and metal buildings with low-slope roofs. These roofs tend to leak at seams, hold standing water and let summer heat pour into the building below.
Spray polyurethane foam roofing creates a single seamless layer over the roof. High-density foam is sprayed onto the prepared surface, filling low spots and building slope toward drains, then a silicone or acrylic coating protects it from sun and weather. It adds continuous insulation above the deck at the same time.
In many cases a foam roof can go over the existing roof after repairs and moisture testing, which avoids the cost and mess of a full tear-off. We inspect every roof and give you a free estimate for repair, recoating or a new foam roof.
Claremore tip
Ask for a moisture survey before foam goes over an existing roof. Trapped wet insulation can blister a new roof and damage the deck.
When Spray Foam Roofing Makes Sense
- ✓Flat or low-slope commercial roofs
- ✓Recurring leaks at seams or flashing
- ✓Ponding water after rain
- ✓Metal roofs with leaking fasteners
- ✓Hot top floors under the roof
- ✓Owners who want to avoid a tear-off
Coatings, Thickness and Hail
Roofing foam is denser than wall or attic foam and is usually at least 1.5 inches thick, often 2 to 3 inches or more to add R-value and create slope. The topcoat protects the foam, so coating type and thickness should be listed in your proposal.
Oklahoma hail is a real consideration. Large hail can damage a foam roof, but most damage is repairable with sealant and a fresh coat rather than a replacement. Inspections after big storms and a recoat every 10 to 20 years keep a foam roof watertight for decades.
Spray Foam Roofing Services We Offer
✓New Foam Roofs
Foam and coating over a prepared deck or existing roof.
✓Roof Recoating
A fresh topcoat to extend the life of a foam roof.
✓Metal Roof Restoration
Sealing seams and fasteners on metal roofs.
✓Ponding Correction
Tapered foam to build slope toward drains.
✓Storm Repairs
Inspection and repair after hail and wind.
Spray Foam Roofing Cost in Claremore, OK
| Project | Typical Range | What Affects It |
|---|---|---|
| New spray foam roof with coating | $4.00–$7.00 per sq ft | Thickness, coating, roof condition |
| Recoat of existing foam roof | $1.50–$3.00 per sq ft | Prep and coating type |
| Metal roof restoration | $3.50–$6.50 per sq ft | Panel and fastener condition |
| Storm repair | Quoted per project | Extent of damage |
Planning ranges for spray foam roofing. Your free estimate follows a roof inspection.
How It Works
- 1
Inspection
We check drainage, decking and trapped moisture.
- 2
Prep
Wet materials are removed and drains, edges and penetrations prepared.
- 3
Foam and Coat
Foam is sprayed to thickness and slope, then coated.
- 4
Final Check
Thickness and drainage are verified and maintenance explained.